TrinkwassermonitorTap water in Germany

Water hardness and tap water in Montabaur

Westerwaldkreis, Rheinland-Pfalz · Postcode 56410

This page is a translation of the German version; the German page is authoritative. German version · Report a translation error

Short answer: The tap water in Montabaur has a total hardness of 4.1 °dH, hardness range “soft” (as of 2025). The tested parameter with a legal limit meets the limit set by the German Drinking Water Ordinance (TrinkwV). Source: test report by Verbandsgemeindewerke Montabaur. WaterScore (provisional): 88.6 out of 100 – the test report contains only 0 of 7 core parameters.

Verified drinking-water values

ParameterValueLimit (TrinkwV)Sampling dateSourceStatus
pH7.986.5–9.52025Verbandsgemeindewerke Montabaurverified
Total hardness4.1 °dH (soft)no legal limit2025Verbandsgemeindewerke Montabaurverified
Electrical conductivity172 µS/cm–2025Verbandsgemeindewerke Montabaurverified

Note from the test report (in the German original): Verbandsgemeindewerke Montabaur · Bekanntmachung der Trinkwasserproben aus dem Jahr 2025; das Blatt nennt je Ort nur das Jahr und die Prüfberichtsnummer. Für Montabaur steht Wasserbezug HB+AB Prinzenschlag. Die Liste gibt pH-Wert, Gesamthärte und Leitfähigkeit an und nennt für die Härte einen Schwankungsbereich. Laut Blatt ergab eine PFAS-Untersuchung am 06.06.2025 keine Funde; einen Zahlenwert nennt es nicht. Das gilt für die Kernstadt und Eschelbach. Die übrigen Stadtteile liegen bei 8,9 bis 12 °dH: Bladernheim 11, Elgendorf 11, Ettersdorf 8,9, Reckenthal 11, Wirzenborn 11, Horessen 12. Welches Wasser an einer bestimmten Adresse ankommt, sagt verbindlich der Versorger.

Is a value wrong or out of date? Report an error – we check every report against the original source.

Water at your own tap: The values describe the water the supplier delivers – not automatically the water at your tap. The water supplier is responsible up to the service connection (Hausanschluss); the building owner is responsible for the pipes beyond it. Lead can dissolve from lead pipes, leaded solder joints or old brass fittings, especially when water has stood in the pipes for a long time (stagnant water); this mainly affects buildings constructed before about 1973. If water has stood in the pipes for several hours, let it run until it comes out cool. If you suspect lead pipes, a lead analysis of the stagnant water by an accredited laboratory will help.

Background on household plumbing, not a measurement: in Montabaur, 40 % of buildings with living space were built before 1970, and a further 15 % between 1970 and 1979 (Zensus 2022, Statistisches Bundesamt, dl-de/by-2-0). (Zensus 2022) According to the German Environment Agency (Umweltbundesamt), lead pipes exist at most in houses built before 1973 – and by no means in all of them. Whether there are any in your house is known to the owner or a plumber. (UBA)

What the values mean for Montabaur

Water hardness in Montabaur in everyday life

At 4.1 °dH, Montabaur is in the hardness range “soft” (soft: below 8.4 °dH, medium: 8.4–14 °dH, hard: above 14 °dH).

Frequently asked questions about tap water in Montabaur

Can you drink the tap water in Montabaur?

According to the verified values, yes: The tested parameter with a legal limit meets the limit set by the German Drinking Water Ordinance (TrinkwV). WaterScore (provisional): 88.6 out of 100 – the test report contains only 0 of 7 core parameters. This applies to the water from the waterworks – restrictions can only arise from old household plumbing.

How hard is the water in Montabaur?

The total hardness is 4.1 °dH – hardness range “soft”. Dose detergent for the hardness range “soft” – the lowest amount on the pack.

Is there PFAS in the tap water in Montabaur?

The published analysis by Verbandsgemeindewerke Montabaur that we evaluated gives no PFAS value. This does not mean there is no PFAS in the water; there is simply no figure for it. Since 12 January 2026, a limit of 0.1 µg/l has applied to the sum of PFAS-20. The supplier can tell you whether PFAS was measured and with what result.

Do I need to filter my tap water in Montabaur?

Based on the verified supplier values, a filter is not necessary. It can make sense if you do not like the taste. If you suspect lead pipes in an old building, a filter does not help; a laboratory analysis at the tap does – that is a question of the household plumbing, not of the water leaving the works.

WaterScore

Data coverage: 0 of 7 core parameters. Not in the test report: Nitrate, Nitrite, Lead, Copper, Arsenic, Uranium and PFAS (sum). Missing parameters are neither estimated nor counted as harmless: the score is based only on the values available and is therefore provisional. It is not a health assessment and says nothing about the water beyond the service connection. Methodology v4: how we calculate the WaterScore.

Evidence: cite and check

Suggested citation: Trinkwassermonitor (2025): Tap water in Montabaur. Values according to the water supplier’s test report, sampling date 2025; at the waterworks, not household plumbing. https://trinkwassermonitor.ink/en/tap-water/montabaur/

JSON: /api/v1/evidence?city=montabaur

Data as of: 2025 · verified: 3 of 3 evaluated parameters.

This page shows only verified test data with sources, or states explicitly where data is missing (no estimated values). Cite as: “Trinkwassermonitor (2026). Tap water in Montabaur. Retrieved from https://trinkwassermonitor.ink/en/tap-water/montabaur/.”

Further information